This is a working overview of alpha-MSH, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2025-10-20 and is reviewed periodically as new material appears.
Melanotan-2 is handled in the laboratory as a lyophilised powder that dissolves readily in water, dimethyl sulfoxide and dimethylformamide, with limited solubility in ethanol. Stock solutions prepared in an organic solvent often precipitate when diluted into aqueous buffer, so gradual dilution with mixing is standard practice. The peptide carries a tryptophan residue and a histidine residue, both sensitive to oxidation and to alkaline conditions. Working solutions are therefore kept near neutral to slightly acidic pH, protected from light, and consumed within the same working session whenever that is practical.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
Routine characterisation relies on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, using a C18 column and a water-acetonitrile gradient containing trifluoroacetic acid. Electrospray ionisation mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidised by-products that co-elute poorly. Sequence and stereochemistry require additional work, such as peptide mapping or amino acid analysis, because a chromatographic purity figure alone does not distinguish a diastereomer from the target peptide. Independent testing of research-grade material frequently shows measured content below the stated label, so a certificate of analysis is best read together with the method that produced it.
The peptide was developed during the 1980s by researchers investigating melanocortin signalling and skin pigmentation pathways. Early work focused on analogues of alpha-melanocyte-stimulating hormone that would resist enzymatic breakdown more effectively than the parent molecule. Melanotan-2 emerged from that programme as a shortened, cyclised variant. Reports describing its synthesis and receptor activity later appeared in the scientific literature. Commercial availability grew through unregulated channels rather than through pharmaceutical approval.
Structurally, Melanotan-2 retains the core recognition motif of alpha-melanocyte-stimulating hormone while adding a lactam bridge that links two side chains and constrains the molecule into a ring. This modification lowers susceptibility to enzymatic degradation. The compound acts as an agonist at melanocortin receptors, particularly subtypes associated with melanin production. Because the same receptor family influences several physiological processes, researchers note that its activity is not confined to pigmentation alone. Receptor selectivity continues to be examined in published studies.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised material may be hygroscopic |
| Solubility class | Soluble in water, DMSO and DMF | Dilution into aqueous buffer can cause precipitation |
| Storage of solid | Minus 20 degrees C, desiccated, dark | Aliquot to limit repeated opening of the vial |
| Storage of solution | Minus 20 to minus 80 degrees C, aliquoted | Avoid repeated freeze-thaw cycles |
| Identity method | Reversed-phase HPLC with mass spectrometry | Retention time and mass are checked together |
Identity testing for a synthetic peptide relies on several complementary methods. Reversed-phase high-performance liquid chromatography separates the target from related impurities and reports purity as a percentage of total peak area. Mass spectrometry confirms molecular mass and can reveal deletions or truncations. Amino acid analysis and peptide mapping provide sequence-level confirmation, while counter-ion content and residual solvents are measured separately. A purity figure alone does not establish identity, so a complete dataset combines chromatographic and spectrometric evidence.
Lyophilized peptide powder is generally stored frozen, protected from light and moisture. Tryptophan residues are susceptible to oxidation, and the lactam bridge can hydrolyze under strongly acidic or basic conditions. Solutions prepared for laboratory work degrade faster than dry powder, and repeated freeze-thaw cycles accelerate loss. Common practice is to aliquot solutions before freezing and to avoid alkaline buffers. Reported stability windows vary with concentration, buffer, and temperature, so exact shelf lives are method-specific rather than universal.
Regulatory status differs by country, and in many places supplying the compound for human consumption is unlawful. Vendors frequently label material as intended for research use only, a designation that shifts stated purpose but does not create a legal pathway for personal use. Certificates of analysis accompanying such products vary widely in detail and provenance. Third-party testing exists but is voluntary, and results are rarely linked to a specific lot in a publicly verifiable way.
Melanotan-2 is a synthetic linear peptide built from seven amino acids arranged in a short chain. Its sequence is commonly written as Ac-Nle-Asp-His-D-Phe-Arg-Trp-Lys-NH2, which includes a modified N-terminus and an amidated C-terminus. The molecule belongs to the melanocortin family and acts as a receptor agonist. Structural features such as the D-phenylalanine residue and the Nle substitution are associated with increased stability against enzymatic degradation relative to the natural parent peptide.
The compound emerged from research programs in the 1980s that examined analogues of alpha-melanocyte-stimulating hormone for pigmentation and photoprotection. Investigators modified the native sequence to extend activity duration and potency. A related analogue, afamelanotide, was developed within the same broad line of inquiry and eventually gained approval in certain jurisdictions for a rare light-sensitivity condition. Melanotan-2 itself did not progress through the same regulatory route and has no approved therapeutic indication.
Melanocortin receptors comprise five subtypes with distinct tissue distributions and functions. Melanotan-2 is described in the literature as a non-selective agonist that engages several of these subtypes, including MC1R, MC3R, MC4R, and MC5R. MC1R is the subtype most directly linked to melanin production in skin cells. Because the compound is not subtype-selective, its observed effects in experimental settings are generally attributed to activity across multiple receptor pathways rather than to a single target.
Lyophilised melanotan-2 is supplied as a solid, which is more stable than a solution. The material is hygroscopic, so weighing is done quickly, in low humidity, with the container kept sealed. Reconstitution usually uses water for injection or bacteriostatic water, added down the wall of the vial to limit foaming. A reconstituted solution is held at 2 to 8 °C and kept away from light. Repeated freezing and thawing of the same vial is avoided because ice crystal formation and concentration effects degrade the peptide.
Reversed-phase high-performance liquid chromatography is the routine method for purity assessment. Peptides absorb near 214 nm because of the peptide bond, and a gradient of acetonitrile in water separates the intact peptide from deletion sequences, oxidised products, and earlier-eluting fragments at neutral pH. Electrospray ionisation mass spectrometry provides an orthogonal check: the measured mass must agree with the theoretical value. Amino acid analysis and peptide mapping confirm structure but are used less often. Reference standards remain scarce because the peptide is not described in any pharmacopoeia.
Over six of these private airline firms offer commercial flights to both domestic and international locations, including Daallo Airlines, Jubba Airways, African Express Airways, East Africa 540, Central Air and Hajara. In 2025, it was announced that Somali Airlines would be making a return with the acquisition of two Airbus A320 aircraft. Possessing the longest coastline on the continent, Somalia has several major seaports. Maritime transport facilities are found in the port cities of Mogadishu, Bosaso, Berbera, Kismayo and Merca. There is also one merchant marine. Established in 2008, it is cargo-based.
==== North American plate ==== Bermuda hotspot (56) 32°36′N 64°18′W, w= 0.3 az= 260° ±15° Yellowstone hotspot (44) 44°30′N 110°24′W, w= 0.8 az= 235° ±5° rate= 26 ±5 mm/yr Possibly related to the Columbia River Basalt Group (17–14 Ma). Raton hotspot (32) 36°48′N 104°06′W, w= 1 az= 240°±4° rate= 30 ±20 mm/yr Anahim hotspot (45) 52°54′N 123°44′W (Nazko Cone)
== Toxicokinetics == The kinetics of labeled derivatives of apamin were studied in vitro and in vivo in mice by Cheng-Raude et al. This shed some light on the kinetics of apamin itself. The key organ for excretion is likely to be the kidney, since enrichment of the labeled derivatives was found there. The peptide apamin is small enough to pass the glomerular barrier, facilitating renal excretion. The central nervous system, contrarily, was found to contain only very small amounts of apamin. This is unexpected, as this is the target organ for neurotoxicity caused by apamin. This low concentration thus appeared to be sufficient to cause the toxic effects. However, these results disagree with a study of Vincent et al. After injection of a supralethal dose of radioactive acetylated apamin in mice, enrichment was found in the spinal cord, which is part of the target organ. Some other organs, including kidney and brain, contained only small amounts of the apamin derivative.
Acne Hair loss Increased risk of heart disease Kidney and liver dysfunction Hypertension Impotence Many prohormone supplements such as 1-testosterone were legal in the United States until reclassified as a Schedule III drug in 2005. However, many illegal prohormones like 1-testosterone are currently being sold legally and marketed by brands such as "Advanced Muscle Science" as 1-androsterone, and are labeled to contain 1-androstenedione-3b-ol,17-one. Only through a recent clinical study has it been shown that the 1-androsterone in the capsules being sold was identified using semi-quantitation and confirmed to be 1-testosterone. Research surrounding other prohormones and prohormone supplements is limited, so many side effects are unknown regarding both legal and illegal prohormone supplements.
Sources: en.wikipedia.org
Anatomy figure: 22:01-03 at Human Anatomy Online, SUNY Downstate Medical Center (Posterior) Anatomy figure: 22:03-02 at Human Anatomy Online, SUNY Downstate Medical Center (Lateral) "Anatomy diagram: 34256.000-2". Roche Lexicon - illustrated navigator. Elsevier. Archived from the original on 2014-01-01.
In 1949, its genetic transmission was determined by E. A. Beet and J. V. Neel. In 1954, it was established that carriers of the abnormal gene are protected to some degree against malaria, which accounts for its persistence in populations threatened by malaria.
The social organization of the earliest Paleolithic (Lower Paleolithic) societies remains largely unknown to scientists, though Lower Paleolithic hominins such as Homo habilis and Homo erectus are likely to have had more complex social structures than chimpanzee societies. Late Oldowan/Early Acheulean humans such as Homo ergaster/Homo erectus may have been the first people to invent central campsites or home bases and incorporate them into their foraging and hunting strategies like contemporary hunter-gatherers, possibly as early as 1.7 million years ago; however, the earliest solid evidence for the existence of home bases or central campsites (hearths and shelters) among humans only dates back to 500,000 years ago. Similarly, scientists disagree whether Lower Paleolithic humans were largely monogamous or polygynous. In particular, the Provisional model suggests that bipedalism arose in pre-Paleolithic australopithecine societies as an adaptation to monogamous lifestyles; however, other researchers note that sexual dimorphism is more pronounced in Lower Paleolithic humans such as Homo erectus than in modern humans, who are less polygynous than other primates, which suggests that Lower Paleolithic humans had a largely polygynous lifestyle, because species that have the most pronounced sexual dimorphism tend more likely to be polygynous. Human societies from the Paleolithic to the early Neolithic farming tribes lived without states and organized governments.
Sources: en.wikipedia.org
== Advisory committees == Concerns have been raised about FDA advisory committees, including conflicts of interest and pharmaceutical industry ties among members of its committees, divergence of agency decisions from advisory committee recommendations, including the controversial decision to approve the Alzheimer's drug aducanumab, and industry-funded support of individuals and organizations submitting public comments.
Graft copolymerization: The growing polystyrene chain reacts with a double bond of the polybutadiene. As a result, several polystyrene chains are attached to one polybutadiene. S represents in the figure the styrene repeat unit B the butadiene repeat unit. However, the middle block often does not consist of such depicted butane homo-polymer but of a styrene-butadiene co-polymer: SSSSSSSSSSSSSSSSSSSBBSBBSBSBBBBSBSSBBBSBSSSSSSSSSSSSSSSSSSSSSSSSSSSSSS By using a statistical copolymer at this position, the polymer becomes less susceptible to cross-linking and flows better in the melt. For the production of SBS, the first styrene is homopolymerized via anionic copolymerization. Typically, an organometallic compound such as butyllithium is used as a catalyst. Butadiene is then added and after styrene again its polymerization. The catalyst remains active during the whole process (for which the used chemicals must be of high purity). The molecular weight distribution of the polymers is very low (polydispersity in the range of 1.05, the individual chains have thus very similar lengths). The length of the individual blocks can be adjusted by the ratio of catalyst to monomer. The size of the rubber sections, in turn, depends on the block length. The production of small structures (smaller than the wavelength of the light) ensure transparency. In contrast to PS-I, however, the block copolymer does not form any particles but has a lamellar structure.
In terms of possible research for Ullrich congenital muscular dystrophy one source indicates that cyclosporine A might be of benefit to individuals with this CMD type. According to a review by Bernardi, et al., cyclosporin A (CsA) used to treat collagen VI muscular dystrophies demonstrates a normalization of mitochondrial reaction to rotenone.
Sources: en.wikipedia.org
Purity is normally stated as an area percentage from high-performance liquid chromatography, for example ninety-five or ninety-eight percent. That figure describes the proportion of ultraviolet-absorbing material eluting as the main peak. It says nothing about water content, counterions, residual solvents or mass fraction of the peptide itself.
Peptides are commonly isolated as acetate or trifluoroacetate salts, and the counterion contributes to total mass. Two vials with identical peptide content can therefore differ in weight and in measured response. Residual trifluoroacetate is also relevant in cell-based work because it can influence membrane behaviour.
Degradation products are often closely related to the parent molecule, making them hard to resolve with a single method. Counterion variability adds a further source of scatter between laboratories. Because no pharmacopoeial monograph exists for melanotan-2, groups rely on method-specific validation rather than a shared reference standard.
It is a synthetic cyclic heptapeptide and an analogue of alpha-melanocyte-stimulating hormone. The molecule is produced by chemical synthesis rather than extracted from a biological source.