The short version of Melanotan II fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-12-05 and is reviewed periodically as new material appears.
Verification of a purchased sample requires documentation linking a batch to a certificate of analysis, and that document should be read for the methods used rather than the headline purity figure. A single chromatographic percentage does not establish identity. Independent laboratories can perform identity and content assays, but no such test establishes that a product is suitable for human use. Claims about efficacy rest largely on small, early studies rather than on replicated controlled trials, and that gap remains open.
Identity testing for a cyclic peptide of this size usually relies on reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The mass spectrum confirms molecular weight, while the chromatographic trace indicates the proportion of related impurities. Tandem mass spectrometry can provide sequence-level information when fragmentation data are compared against a reference standard. Nuclear magnetic resonance is sometimes used to confirm the lactam bridge, although it requires more material and greater operator expertise than routine chromatographic methods.
The compound was developed in the late 1980s and 1990s by academic researchers investigating photoprotection. The rationale held that stimulating melanin production might reduce ultraviolet damage to skin and lower skin cancer risk. Early work examined receptor binding, pigment response, and short-term tolerability in small studies. That program did not produce an approved drug, and formal development stalled after early-phase trials. Whether induced pigmentation confers meaningful photoprotection remains an open question.
Outside regulated medicine, melanotan II circulates through online vendors as a research chemical, often marketed for tanning. Products sold this way vary widely in purity, concentration, and labeling accuracy, and independent testing has documented discrepancies. Published reports describe both pigment effects and adverse reactions, including nausea, flushing, and darkening of existing moles. Long-term safety data are sparse, and no large controlled trial has established a risk profile. Questions about cumulative effects on melanocytes remain unresolved in the literature.
Melanotan II is a synthetic peptide analog modeled on alpha-melanocyte-stimulating hormone, a naturally occurring signaling peptide involved in pigmentation. Its structure is a cyclic heptapeptide containing two non-natural substitutions, norleucine at position four and D-phenylalanine at position seven. These modifications resist enzymatic breakdown and extend the molecule's activity relative to the native hormone. The compound binds melanocortin receptors and is studied mainly as a pharmacological tool rather than a therapeutic product. It has never received approval as a medicine in any major jurisdiction.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white solid | Lyophilised cake or flake |
| Solubility class | Soluble in water and aqueous buffer | Also soluble in some polar organic solvents |
| Typical storage temperature | Minus 20 degrees Celsius or below | Desiccated and protected from light |
| Typical analytical method | LC-MS/MS | Reversed-phase separation with mass detection |
| Molecular formula | C50H69N15O9 | Free base; salt forms differ |
Lyophilised melanotan-2 is supplied as a solid, which is more stable than a solution. The material is hygroscopic, so weighing is done quickly, in low humidity, with the container kept sealed. Reconstitution usually uses water for injection or bacteriostatic water, added down the wall of the vial to limit foaming. A reconstituted solution is held at 2 to 8 °C and kept away from light. Repeated freezing and thawing of the same vial is avoided because ice crystal formation and concentration effects degrade the peptide.
Reversed-phase high-performance liquid chromatography is the routine method for purity assessment. Peptides absorb near 214 nm because of the peptide bond, and a gradient of acetonitrile in water separates the intact peptide from deletion sequences, oxidised products, and earlier-eluting fragments at neutral pH. Electrospray ionisation mass spectrometry provides an orthogonal check: the measured mass must agree with the theoretical value. Amino acid analysis and peptide mapping confirm structure but are used less often. Reference standards remain scarce because the peptide is not described in any pharmacopoeia.
Two structural changes distinguish the synthetic peptide from the natural hormone. A norleucine residue replaces methionine at one position, and a D-configured phenylalanine replaces the natural L-form at another. Both substitutions slow enzymatic breakdown, which extends the molecule's persistence relative to the parent hormone. The lactam bridge further constrains the backbone into a stable conformation. These features are standard design strategies in peptide chemistry and are not unique to this compound; they appear across many research peptides built for improved stability.
The compound was developed in the late 1980s and early 1990s by academic researchers investigating melanocortin signaling and pigmentation. Early work explored whether synthetic analogs could reproduce effects of the natural hormone under controlled conditions. The molecule never advanced through the full regulatory pathway required for approval as a medicine. From the mid-2000s onward it appeared in unregulated consumer markets, often distributed through informal channels. That gap between research origins and commercial availability shapes how the compound is discussed today.
Melanotan-2 is a synthetic peptide designed as an analog of alpha-melanocyte-stimulating hormone, a signaling molecule produced in the pituitary and skin. Its structure is a linear chain of seven amino acids that folds into a ring through an internal lactam bridge joining two side chains. The compound is sometimes written as MT-II or MEL-2 in informal and commercial contexts. It belongs to the melanocortin peptide family, a group of short signaling molecules that share a conserved core sequence recognized by melanocortin receptors.
Reported observations after unregulated use include shifts in skin pigmentation and, in some accounts, unintended changes to moles and other lesions. Whether these outcomes are causally linked to the compound, and how often they occur, remain open questions because controlled data are scarce. The absence of standardised dosing and verified product purity complicates interpretation. Researchers have called for better surveillance and analytical characterisation of samples obtained outside regulated channels. Conclusions drawn from anecdotal evidence should be treated as provisional.
Melanotan-2 has not received marketing authorisation from major regulatory agencies for any therapeutic indication. Several jurisdictions classify it as a prescription-only medicine or a controlled substance when supplied for human use. Because approved products do not exist, material sold online usually sits outside pharmaceutical supply chains and formal quality oversight. Regulators have issued public notices describing the compound as unapproved. Enforcement varies, and the legal position differs between countries, which complicates any single general statement about its status.
Scientific discussion of Melanotan-2 spans pharmacology, dermatology, and public-health literature. Laboratory studies examine its receptor binding and cellular effects, while clinical reports describe outcomes observed after unregulated use. These two bodies of work differ in rigour and intent. Peer-reviewed trials of the compound as a medicine are limited, so much of the available information comes from case reports and surveillance data. Authors frequently note the gap between experimental findings and real-world use.
== Academic career == Shulman began his academic career at Harvard Medical School, serving as an instructor and then as an assistant professor of medicine from 1984 to 1987. In 1987, he joined the faculty at Yale University as an assistant professor of medicine. He was promoted to associate professor in 1989 and became a full professor in both internal medicine and cellular and molecular physiology in 1996. From 1987 to 1993, he concurrently served as a lecturer in Yale's Department of Molecular Biophysics and Biochemistry. In 2009, he was appointed the inaugural George R. Cowgill Professor of Physiological Chemistry at Yale University, a position he continues to hold. Shulman served as Associate Director of both the Yale Diabetes Endocrinology Research Center and the Yale Medical Scientist Training Program from 1992 to 2012. In 2012, he became Co-Director of the Yale Diabetes Research Center. He has served on the editorial boards of journals including the Journal of Clinical Investigation, Cell Metabolism, Science Translational Medicine, and Proceedings of the National Academy of Sciences. He was also an Investigator of the Howard Hughes Medical Institute for 21 years and is now an Investigator Emeritus.
=== Disorders of lipoid metabolism === 272 Disorders of lipoid metabolism 272.0 Pure hypercholesterolemia Fredrickson Type IIa hyperlipoproteinemia Familial hypercholesterolemia 272.1 Pure hyperglyceridemia Hypertriglyceridemia, essential Fredrickson Type IV hyperlipoproteinemia 272.2 Hyperlipidemia, mixed Fredrickson Type IIb or III hyperlipoproteinemia Tubo-eruptive xanthoma Xanthoma tuberosum 272.3 Hyperchylomicronemia Bürger-Grütz syndrome Fredrickson type I or V hyperlipoproteinemia Hyperlipidemia, Group D Mixed hyperglyceridemia 272.4 Other and unspecified hyperlipidemia Alpha-lipoproteinemia Combined hyperlipidemia 272.5 Lipoprotein deficiencies Abetalipoproteinemia Bassen-Kornzweig syndrome High-density lipoid deficiency Hypoalphalipoproteinemia Hypobetalipoproteinemia (familial) 272.6 Lipodystrophy 272.7 Lipidoses Gaucher's disease Niemann-Pick disease Sea-blue histiocyte syndrome 272.8 Other disorders of lipoid metabolism
The first application of barrier membranes in the mouth occurred in 1982 in the context of regeneration of periodontal tissues via GTR, as an alternative to resective surgical procedures to reduce pocket depths. A barrier membrane is utilized in the GBR technique to cover the bone defect and create a secluded space, which prevents the connective tissue from growing into the space and facilitates the growth priority of bone tissue. An added benefit of the membrane is that it provides protection of the wound from mechanical disruption and salivary contamination. Barrier membrane criteria should be as follows:
=== Legal status === Effective August 2014, tramadol has been placed into Schedule IV of the federal Controlled Substances Act in the United States. Before that, some US states had already classified tramadol as a Schedule IV controlled substance under their respective state laws. Tramadol is classified in Schedule 4 (prescription only) in Australia, rather than as a Schedule 8 Controlled Drug (possession without authority illegal) like most other opioids. Effective May 2008, Sweden classified tramadol as a controlled substance in the same category as codeine and dextropropoxyphene, but allows a normal prescription to be used. In June 2014, the United Kingdom's Home Office classified tramadol as a Class C, Schedule 3 controlled drug, but exempted it from the safe custody requirement. In October 2023, New Zealand's Medsafe reclassified tramadol as a Class C2 Controlled Drug (in addition to its existing status as a prescription only medication). Effective 22 August 2025, the government of Liberia increased regulations on tramadol. Its use was "strictly limited to licensed hospital settings under the direct supervision of professional medical staff" according to the Liberian Observer. Liberian health authorities claimed that tramadol was the "most widely abused drug" in the country.
Sources: en.wikipedia.org
== Metallurgy == In metallurgy, gas flushing removes dissolved gases from the molten metal prior to the material being processed. For example, before casting aluminium alloys, argon bubbles are injected into liquid aluminium using a rotary degasser. The argon bubbles rise to the surface, bringing with them some of the dissolved hydrogen. The degassing step reduces the occurrence of hydrogen gas porosity. In the steel making process, this method is used very commonly for duplex steel and some high reactivity metals.
After an incompatible transfusion the recipient may develop an antibody to the antigen and will react to any further incompatible transfusions. This antibody is important because it is the most frequent cause of hemolytic disease of the newborn. Incompatible red blood cells are sometimes given to recipients who will never become pregnant, such as males or postmenopausal women, as long as they do not have an antibody, since the greatest risk of Rh incompatible blood is to current or future pregnancies. For RBCs, type O negative blood is considered a "universal donor" as recipients with types A, B, or AB can almost always receive O negative blood safely. Type AB positive is considered a "universal recipient" because they can receive the other ABO/Rh types safely. These are not truly universal, as other red cell antigens can further complicate transfusions. There are many other human blood group systems and most of them are only rarely associated with transfusion problems. A screening test is used to identify if the recipient has any antibodies to any of these other blood group systems. If the screening test is positive, a complex set of tests must follow to identify which antibody the recipient has by process of elimination. Finding suitable blood for transfusion when a recipient has multiple antibodies or antibodies to extremely common antigens can be very difficult and time-consuming. Because this testing can take time, doctors will sometimes order a unit of blood transfused before it can be completed if the recipient is in critical condition.
=== Stress === A high proportion of patients with an acute stress such as stroke or myocardial infarction may develop hyperglycemia, even in the absence of a diagnosis of diabetes. (Or perhaps stroke or myocardial infarction was caused by hyperglycemia and undiagnosed diabetes.) Human and animal studies suggest that this is not benign, and that stress-induced hyperglycemia is associated with a high risk of mortality after both stroke and myocardial infarction. Somatostatinomas and aldosteronoma-induced hypokalemia can cause hyperglycemia but usually disappears after the removal of the tumour. Stress causes hyperglycaemia via several mechanisms, including through metabolic and hormonal changes, and via increased proinflammatory cytokines that interrupt carbohydrate metabolism, leading to excessive glucose production and reduced uptake in tissues. Hormones such as the growth hormone, glucagon, cortisol, and catecholamines, can cause hyperglycemia when they are present in the body in excess amounts.
Sources: en.wikipedia.org
Mass spectrometry combined with liquid chromatography provides both molecular weight confirmation and a measure of related impurities. Tandem mass spectrometry adds sequence information. A purity percentage reported without a mass measurement does not confirm what the material is.
No. Lyophilisation slows degradation rather than stopping it, and the rate depends on residual moisture, temperature and light exposure. Freezer storage extends useful life but does not make the material permanent.
A certificate is only as good as its traceability to a specific batch and a named laboratory. Documents lacking batch numbers, method descriptions or laboratory identifiers carry little weight. Confirming what was actually received generally requires a separate test of the material in hand.
It is a synthetic cyclic peptide designed as an analog of alpha-melanocyte-stimulating hormone. It acts on melanocortin receptors and is best known from research into pigmentation. It is not an approved pharmaceutical product.