alpha-MSH analog comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-07-02. Where a claim depends on a specific study, the study is described rather than over-claimed.
Melanotan-2 is handled in the laboratory as a lyophilised powder that dissolves readily in water, dimethyl sulfoxide and dimethylformamide, with limited solubility in ethanol. Stock solutions prepared in an organic solvent often precipitate when diluted into aqueous buffer, so gradual dilution with mixing is standard practice. The peptide carries a tryptophan residue and a histidine residue, both sensitive to oxidation and to alkaline conditions. Working solutions are therefore kept near neutral to slightly acidic pH, protected from light, and consumed within the same working session whenever that is practical.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
Routine characterisation relies on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, using a C18 column and a water-acetonitrile gradient containing trifluoroacetic acid. Electrospray ionisation mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidised by-products that co-elute poorly. Sequence and stereochemistry require additional work, such as peptide mapping or amino acid analysis, because a chromatographic purity figure alone does not distinguish a diastereomer from the target peptide. Independent testing of research-grade material frequently shows measured content below the stated label, so a certificate of analysis is best read together with the method that produced it.
Melanotan II binds several melanocortin receptor subtypes rather than a single target. MC1R on melanocytes drives melanin synthesis, while MC3R and MC4R participate in energy balance, appetite, and sexual response pathways. This lack of selectivity explains why reported effects extend beyond skin darkening. Substitutions at positions four and seven, including norleucine and D-phenylalanine, increase potency and resistance to peptidases. Understanding which receptor mediates which effect remains an active area of investigation.
Published human data come mostly from small, short studies rather than large controlled trials. Reported outcomes include increased skin pigmentation and, in some reports, effects on appetite and libido, but sample sizes are small and follow-up is limited. Whether long-term use produces durable pigment changes or adverse effects is not established. Because products sold outside pharmacies are not standardized, the actual content of any given vial is often unknown. Independent testing of such material is uncommon.
Melanotan II is a synthetic cyclic heptapeptide analog derived from the core sequence of alpha-melanocyte-stimulating hormone. Researchers at the University of Arizona synthesized it during the 1980s while studying pigmentation and appetite signaling. The compound is not an approved medicine in any major jurisdiction and appears mainly in laboratory and research-chemical settings. Its structure incorporates a lactam bridge between side chains, which constrains the ring and slows enzymatic breakdown relative to the natural hormone.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised material may be hygroscopic |
| Solubility class | Soluble in water, DMSO and DMF | Dilution into aqueous buffer can cause precipitation |
| Storage of solid | Minus 20 degrees C, desiccated, dark | Aliquot to limit repeated opening of the vial |
| Storage of solution | Minus 20 to minus 80 degrees C, aliquoted | Avoid repeated freeze-thaw cycles |
| Identity method | Reversed-phase HPLC with mass spectrometry | Retention time and mass are checked together |
Identity testing for a synthetic peptide relies on several complementary methods. Reversed-phase high-performance liquid chromatography separates the target from related impurities and reports purity as a percentage of total peak area. Mass spectrometry confirms molecular mass and can reveal deletions or truncations. Amino acid analysis and peptide mapping provide sequence-level confirmation, while counter-ion content and residual solvents are measured separately. A purity figure alone does not establish identity, so a complete dataset combines chromatographic and spectrometric evidence.
Lyophilized peptide powder is generally stored frozen, protected from light and moisture. Tryptophan residues are susceptible to oxidation, and the lactam bridge can hydrolyze under strongly acidic or basic conditions. Solutions prepared for laboratory work degrade faster than dry powder, and repeated freeze-thaw cycles accelerate loss. Common practice is to aliquot solutions before freezing and to avoid alkaline buffers. Reported stability windows vary with concentration, buffer, and temperature, so exact shelf lives are method-specific rather than universal.
Regulatory status differs by country, and in many places supplying the compound for human consumption is unlawful. Vendors frequently label material as intended for research use only, a designation that shifts stated purpose but does not create a legal pathway for personal use. Certificates of analysis accompanying such products vary widely in detail and provenance. Third-party testing exists but is voluntary, and results are rarely linked to a specific lot in a publicly verifiable way.
Melanotan-2, also written Melanotan II, is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone. Its sequence is Ac-Nle-cyclo[Asp-His-D-Phe-Arg-Trp-Lys]-NH2, and the lactam bridge between the aspartate and lysine side chains constrains the peptide into a ring. This structural change increases receptor affinity and metabolic stability relative to the native hormone. The compound was created in the 1980s as a research tool for studying pigmentation biology.
Melanocytes are the pigment-producing cells of the skin, and they carry melanocortin-1 receptors on their surface. When the receptor is activated, cyclic adenosine monophosphate rises inside the cell and raises the activity of enzymes such as tyrosinase, which increases melanin output. Melanotan-2 binds melanocortin-1 receptors in vitro and in animal models, and this binding is generally described as the basis for the tanning effect. Other receptors account for different effects: melanocortin-4 receptors contribute to appetite and erectile signalling, while melanocortin-3 and melanocortin-5 receptors contribute to energy balance and exocrine function.
Early published reports described melanotan-2 as a tanning agent without sun protection, which means darkening is not the same as protection against ultraviolet radiation. Later studies explored the peptide in erectile dysfunction, hemorrhagic shock, and some skin conditions. No regulator in the United States or Europe has approved it for clinical use. Many products labelled melanotan-2 are sold without approval and their identity and purity are unverified. Its long-term safety in humans remains an open question.
=== Glycine === Glycine is biosynthesized from serine, catalyzed by serine hydroxymethyltransferase (SHMT). The enzyme effectively replaces a hydroxymethyl group with a hydrogen atom. SHMT is coded by the gene glyA. The regulation of glyA is complex and is known to incorporate serine, glycine, methionine, purines, thymine, and folates, The full mechanism has yet to be elucidated. The methionine gene product MetR and the methionine intermediate homocysteine are known to positively regulate glyA. Homocysteine is a coactivator of glyA and must act in concert with MetR. On the other hand, PurR, a protein which plays a role in purine synthesis and S-adeno-sylmethionine are known to down regulate glyA. PurR binds directly to the control region of glyA and effectively turns the gene off so that glycine will not be produced by the bacterium.
==== Direct calculation when friction loss S is known ==== In typical engineering applications, there will be a set of given or known quantities. The acceleration of gravity g and the kinematic viscosity of the fluid ν are known, as are the diameter of the pipe D and its roughness height ε. If as well the head loss per unit length S is a known quantity, then the friction factor fD can be calculated directly from the chosen fitting function. Solving the Darcy–Weisbach equation for √fD,
Tc is maximal near 92 K (−181.2 °C) when x ≈ 0.15 and the structure is orthorhombic. Superconductivity disappears at x ≈ 0.6, where the structural transformation of YBCO occurs from orthorhombic to tetragonal.
With a reduced response to insulin, the beta cells of the pancreas secrete increasing amounts of insulin in response to the continued high blood glucose levels resulting in hyperinsulinemia. In insulin resistant tissues, a threshold concentration of insulin is reached causing the cells to uptake glucose and therefore decreases blood glucose levels. Studies have shown that the high levels of insulin resulting from insulin resistance might enhance insulin resistance. Studies on mice with genetically reduced circulating insulin suggest that hyperinsulinemia plays a causal role in high fat diet-induced obesity. In this study, mice with reduced insulin levels expended more energy and had fat cells that were reprogrammed to burn some energy as heat. Hyperinsulinemia in neonates can be the result of a variety of environmental and genetic factors. If the mother of the infant is a diabetic and is not able to properly control her blood glucose levels, the hyperglycemic maternal blood can create a hyperglycemic environment in the fetus. To compensate for the increased blood glucose levels, fetal pancreatic beta cells can undergo hyperplasia. The rapid division of beta cells results in increased levels of insulin being secreted to compensate for the high blood glucose levels. Following birth, the hyperglycemic maternal blood is no longer accessible to the neonate resulting in a rapid drop in the newborn's blood glucose levels. As insulin levels are still elevated this may result in hypoglycemia.
Sources: en.wikipedia.org
== Media == Cold Spring Record began publishing weekly in October 1899 and is still in publication. Tri-City Cable]: Channel 10 is the local public access television station for the communities of Richmond, Cold Spring and Rockville, broadcasting news on community events and coverage of local government meetings.
== External links == Osteocalcin at the U.S. National Library of Medicine Medical Subject Headings (MeSH) Overview of all the structural information available in the PDB for UniProt: Q8HYY9 (Pig Osteocalcin) at the PDBe-KB.
Gentle, non-irritating cleansers and moisturizers are often used alongside medicated treatments to maintain the skin barrier. The condition is common in infants within the first three months of age and adults aged 30 to 70 years. It is more common in males, African Americans, the immunocompromised (such as those with HIV), and those with Parkinson's disease.
Sources: en.wikipedia.org
Purity is normally stated as an area percentage from high-performance liquid chromatography, for example ninety-five or ninety-eight percent. That figure describes the proportion of ultraviolet-absorbing material eluting as the main peak. It says nothing about water content, counterions, residual solvents or mass fraction of the peptide itself.
Peptides are commonly isolated as acetate or trifluoroacetate salts, and the counterion contributes to total mass. Two vials with identical peptide content can therefore differ in weight and in measured response. Residual trifluoroacetate is also relevant in cell-based work because it can influence membrane behaviour.
Degradation products are often closely related to the parent molecule, making them hard to resolve with a single method. Counterion variability adds a further source of scatter between laboratories. Because no pharmacopoeial monograph exists for melanotan-2, groups rely on method-specific validation rather than a shared reference standard.
No regulator in a major market has approved it for human use. It appears in research settings and in products marketed outside pharmacy channels. Legal status for personal possession varies by country.