Everything below concerns melanocortin receptors. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2026-05-29. Numbers and descriptions here follow the published literature rather than marketing material.
Melanotan II is a synthetic peptide analog modeled on alpha-melanocyte-stimulating hormone, a naturally occurring signaling peptide involved in pigmentation. Its structure is a cyclic heptapeptide containing two non-natural substitutions, norleucine at position four and D-phenylalanine at position seven. These modifications resist enzymatic breakdown and extend the molecule's activity relative to the native hormone. The compound binds melanocortin receptors and is studied mainly as a pharmacological tool rather than a therapeutic product. It has never received approval as a medicine in any major jurisdiction.
The compound was developed in the late 1980s and 1990s by academic researchers investigating photoprotection. The rationale held that stimulating melanin production might reduce ultraviolet damage to skin and lower skin cancer risk. Early work examined receptor binding, pigment response, and short-term tolerability in small studies. That program did not produce an approved drug, and formal development stalled after early-phase trials. Whether induced pigmentation confers meaningful photoprotection remains an open question.
Lyophilised melanotan-2 is supplied as a solid, which is more stable than a solution. The material is hygroscopic, so weighing is done quickly, in low humidity, with the container kept sealed. Reconstitution usually uses water for injection or bacteriostatic water, added down the wall of the vial to limit foaming. A reconstituted solution is held at 2 to 8 °C and kept away from light. Repeated freezing and thawing of the same vial is avoided because ice crystal formation and concentration effects degrade the peptide.
Reversed-phase high-performance liquid chromatography is the routine method for purity assessment. Peptides absorb near 214 nm because of the peptide bond, and a gradient of acetonitrile in water separates the intact peptide from deletion sequences, oxidised products, and earlier-eluting fragments at neutral pH. Electrospray ionisation mass spectrometry provides an orthogonal check: the measured mass must agree with the theoretical value. Amino acid analysis and peptide mapping confirm structure but are used less often. Reference standards remain scarce because the peptide is not described in any pharmacopoeia.
Regulatory treatment varies by country. In the United States the peptide is not approved as a medicine, and products offered for human use may be treated as unapproved new drugs; some states also restrict sale. Australia, the United Kingdom, and European Union member states apply comparable restrictions to unapproved peptide products. Border agencies have seized shipments labelled as research chemicals. Classification may change over time, and the legal position for personal importation is not clearly settled in most published guidance.
| Property | Value | Notes |
|---|---|---|
| Chemical class | Synthetic cyclic heptapeptide | Belongs to the melanocortin agonist family |
| Key substitutions | Nle4 and D-Phe7 | Improve resistance to enzymatic degradation |
| Molecular formula | C50H69N15O9 | Approximately 1024 g/mol |
| Regulatory status | Not approved as a medicine | Distributed as a research chemical |
| Common synonyms | Melanotan II, MT-II, MT-2 | Spelling varies across sources |
Melanotan-2 is a synthetic peptide designed as an analog of alpha-melanocyte-stimulating hormone, a signaling molecule produced in the pituitary and skin. Its structure is a linear chain of seven amino acids that folds into a ring through an internal lactam bridge joining two side chains. The compound is sometimes written as MT-II or MEL-2 in informal and commercial contexts. It belongs to the melanocortin peptide family, a group of short signaling molecules that share a conserved core sequence recognized by melanocortin receptors.
Two structural changes distinguish the synthetic peptide from the natural hormone. A norleucine residue replaces methionine at one position, and a D-configured phenylalanine replaces the natural L-form at another. Both substitutions slow enzymatic breakdown, which extends the molecule's persistence relative to the parent hormone. The lactam bridge further constrains the backbone into a stable conformation. These features are standard design strategies in peptide chemistry and are not unique to this compound; they appear across many research peptides built for improved stability.
Melanotan-2 has not received marketing authorisation from major regulatory agencies for any therapeutic indication. Several jurisdictions classify it as a prescription-only medicine or a controlled substance when supplied for human use. Because approved products do not exist, material sold online usually sits outside pharmaceutical supply chains and formal quality oversight. Regulators have issued public notices describing the compound as unapproved. Enforcement varies, and the legal position differs between countries, which complicates any single general statement about its status.
Scientific discussion of Melanotan-2 spans pharmacology, dermatology, and public-health literature. Laboratory studies examine its receptor binding and cellular effects, while clinical reports describe outcomes observed after unregulated use. These two bodies of work differ in rigour and intent. Peer-reviewed trials of the compound as a medicine are limited, so much of the available information comes from case reports and surveillance data. Authors frequently note the gap between experimental findings and real-world use.
Pharmacologically, melanotan-2 behaves as a non-selective agonist across the melanocortin receptor family. Binding at MC1R on dermal melanocytes promotes eumelanin synthesis, which underlies the tanning response described in early human work. Activity at the centrally expressed MC4R receptor is associated with reported effects on appetite and erectile function. Because the peptide does not discriminate strongly among receptor subtypes, attributing any single observed effect to one receptor pathway is generally not possible without selective antagonists or receptor knockout models.
Research interest has centred on photoprotection and pigmentation, with a smaller body of work on appetite and sexual function. Published human data remain limited to small, frequently uncontrolled studies, and the compound has never received marketing approval from a national medicines regulator. Most laboratory work treats it as a pharmacological tool for probing melanocortin signalling in cell culture or animal models. Whether pigmentation changes observed in people translate into measurable protection against ultraviolet-induced DNA damage remains an open question.
Routine characterisation relies on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, using a C18 column and a water-acetonitrile gradient containing trifluoroacetic acid. Electrospray ionisation mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidised by-products that co-elute poorly. Sequence and stereochemistry require additional work, such as peptide mapping or amino acid analysis, because a chromatographic purity figure alone does not distinguish a diastereomer from the target peptide. Independent testing of research-grade material frequently shows measured content below the stated label, so a certificate of analysis is best read together with the method that produced it.
Melanotan-2 is handled in the laboratory as a lyophilised powder that dissolves readily in water, dimethyl sulfoxide and dimethylformamide, with limited solubility in ethanol. Stock solutions prepared in an organic solvent often precipitate when diluted into aqueous buffer, so gradual dilution with mixing is standard practice. The peptide carries a tryptophan residue and a histidine residue, both sensitive to oxidation and to alkaline conditions. Working solutions are therefore kept near neutral to slightly acidic pH, protected from light, and consumed within the same working session whenever that is practical.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
== Deaths == In the United States, in 2003, a 17-year-old who, according to his parents, was self-treating his anxiety with home-brewed poppy seed tea, died of pulmonary edema caused by acute morphine and codeine intoxication. A Drug Alert posted by the DOJ in 2010 pointed to five deaths possibly resulting from drinking of poppy tea. Since 2010, not less than 10 deaths presumably related to poppy tea consumption were reported by the FDA's Center for Food Safety and Applied Nutrition Adverse Event Reporting System (CAERS). In Canada, on 19 May 2012, a 19-year-old from Nova Scotia died after drinking the tea from a poppy seed pod he purchased on the Internet. In November 2012, a Tasmanian youth died after drinking tea brewed from seed heads, and a 50-year-old Tasmanian man died in similar circumstances in February 2011. Some instances of death or injury associated with the consumption of poppy seed tea have involved users who combined the beverage with other nervous system depressants (i.e. alcohol, tranquillizers, benzodiazepines).
It might be possible to print organs, or possibly entire organisms using additive manufacturing techniques. A recent innovative method of construction uses an ink-jet mechanism to print precise layers of cells in a matrix of thermo-reversible gel. Endothelial cells, the cells that line blood vessels, have been printed in a set of stacked rings. When incubated, these fused into a tube. This technique has been referred to as "bioprinting" within the field as it involves the printing of biological components in a structure resembling the organ of focus. The field of three-dimensional and highly accurate models of biological systems is pioneered by multiple projects and technologies including a rapid method for creating tissues and even whole organs involve a 3D printer that can bio-print the scaffolding and cells layer by layer into a working tissue sample or organ. The device is presented in a TED talk by Dr. Anthony Atala, M.D. the Director of the Wake Forest Institute for Regenerative Medicine, and the W.H. Boyce Professor and Chair of the Department of Urology at Wake Forest University, in which a kidney is printed on stage during the seminar and then presented to the crowd. It is anticipated that this technology will enable the production of livers in the future for transplantation and theoretically for toxicology and other biological studies as well. In 2015 Multi-Photon Processing (MPP) was employed for in vivo experiments by engineering artificial cartilage constructs.
== Public consumption == The center at the Ames Research Center in California began researching how to allow visitors to taste astronaut food in 1973. They contacted American Outdoor Products and Backpacker's Pantry, the latter becoming a known source for freeze-dried meals like stews and even pasta dishes for serious campers and backpackers. NASA/AMES worked with American Outdoor Products to produce the world first freeze-dried ice cream and Astronaut Foods with the goal to allow people to see what space food tastes like.
Sources: en.wikipedia.org
== Further reading == Grimes, D. S.; Gordon, C. (1978). "Satiety value of wholemeal and white bread". The Lancet. 312 (8080): 106. doi:10.1016/s0140-6736(78)91421-6. PMID 78273. Merrill, E. P.; et al. (2002). "A comparison of satiety measures". Appetite. 39 (2): 181–183. doi:10.1006/appe.2002.0496. PMID 12354688. Rolls, Barbara J.; Hetherington, Marion; J. Burley, Victoria (1988). "The specificity of satiety: The influence of foods of different macronutrient content on the development of satiety". Physiology & Behavior. 43 (2). Elsevier: 145–153. doi:10.1016/0031-9384(88)90230-2. PMID 3212049. Brunstrom, J.M.; et al. (2008). "Measuring 'expected satiety' in a range of common foods using a method of constant stimuli". Appetite. 51 (3): 604–14. doi:10.1016/j.appet.2008.04.017. PMID 18547677.
When there is an injury to a blood vessel, the endothelial cells can release various vasoconstrictor substances, such as endothelin and thromboxane, to induce the constriction of the smooth muscles in the vessel wall. This helps reduce blood flow to the site of injury and limits bleeding.
== Sunderland's classification == In 1951, Sunderland expanded Seddon's classification to five degrees. The first two are the same as Seddon's. With each degree, the severity of the injury increases and has larger structural disruption and poorer prognosis. Sunderland's third-degree and fourth-degree are included within Seddon's axonotmensis. Sunderland's third-degree is nerve fiber interruption. This includes an endoneurium lesion with disruption of the axon and endoneurium, but an intact epineurium and perineurium. Recovery from a third-degree injury may require surgical intervention due to misdirected regeneration that is caused by endoneurial damage. In fourth-degree injury, only the epineurium remain intact, and a complete block to axonal regeneration could occur, requiring surgical repair. Sunderland's fifth-degree is included within Seddon's neurotmesis. Fifth-degree lesion is a complete transection of the nerve, including the epineurium. Recovery requires appropriate surgical treatment since there is no spontaneous recovery expected.
Sources: en.wikipedia.org
It is a synthetic cyclic peptide designed as an analog of alpha-melanocyte-stimulating hormone. It acts on melanocortin receptors and is best known from research into pigmentation. It is not an approved pharmaceutical product.
No regulatory agency has approved it for any indication. It is encountered as a research chemical sold outside pharmaceutical supply chains. Products marketed this way are not subject to the manufacturing and labeling requirements that apply to approved drugs.
Reports describe increased skin pigmentation as well as side effects such as nausea, flushing, and changes to existing moles. Much of the evidence comes from small studies and case reports rather than large trials. The long-term safety profile is therefore uncertain.
Low temperature slows hydrolysis and oxidation, the two main routes by which the peptide backbone and side chains are modified. A lyophilised powder stored at −20 °C is more stable than one kept at room temperature, and once the material is dissolved the degradation rate rises, making refrigeration more important.